HP & Torque: 350 HP / 350 FT LBS
Compression Ratio: 9.4:1
Aluminum Heads
Hydraulic Roller Cam
Forged Crank
Hypereutectic Pistons
BLOCK:
NEW BluePrint Cast Iron Block
4-Bolt Main
4.000" Bore
1-Piece Rear Main Seal
Mech fuel pump provision: Yes
Passenger Side Dipstick
Drilled and tapped for clutch linkage
ROTATING ASSEMBLY:
New BluePrint Forged Crankshaft
3.250" Stroke
Forged 5.700" connecting rods w/ 150,000 psi bolts
Hypereutectic pistons
Internal Front/ External Rear
CYLINDER HEADS:
BluePrint Aluminum Cylinder Heads
64cc chamber
2.02" intake/1.60" exhaust valves
195cc intake/75cc exhaust runners
CAM SPECS:
Cam Type: Roller
.495 Intake .502 Exhaust
220 Intake / 224 Exhaust duration
@ .050, 114 ° lobe separation angle
IGNITION TIMING:
32-34 Degrees Total at 3500 RPM
ALSO INCLUDES:
670 CFM carburetor
Premium Vintage Valve covers
Premium Vintage Air Cleaner
6.75 inch Harmonic balancer
Spark plugs
Under Header Spark plug wires (Perfect for Rams Horn exhaust manifolds)
Fuel Pump and feed line
Oil pan
Timing cover
Aluminum Intake Manifold
Small cap Ready to run distributor equipped with Tach Drive and coil
Front Accessory Drive with Water Pump, A/C Compressor, Alternator, and Power Steering Pump
Thermostat and thermostat housing
NOTES:
Not for use in pollution-controlled vehicles.
The front accessory drive on this engine fits many vehicles, however it is the customer responsibility to accurately measure and confirm fitment. Note this is a low-profile design, but things such as power steering hoses, alternator wiring, and additional fittings/fabrication may be required on some vehicles.
BluePrint Engines BP327CTFKV
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov