BluePrint Engines Muscle Car LS Engine Swap Air Intake Kit with GM MAF (Universal; Some Adaptation May Be Required)

BluePrint Engines Air Intake Kit for LS, Hemi, and Any Front Throttle Body Muscle Car Type Swap Engine
Includes Filter, Tube, MAF Receptacle, Block-off, Clamps, Couplers and Hardware
This BluePrint Engines Air Intake Kit is Designed for Use with Any Front Facing Throttle Body Equipped Engine Such as PSLS427, PSLS376, or PS426 Based Engines. Has Been Tested on Throttle Bodies from 80mm-102mm
CONTENTS:
Red, Oilless Cotton Gauze Washable Filter
Measurements
7-inch Total Heigh From Base
4.750" Black Silicon Cap
6-inch Inlet
Aluminum Intake Tube with 97.5mm ID
5 Stainless Steel Hose Clamps
Tube to Filter Adapter
Three Silicon Couplers
Silicon Clean Air Hose
Vacuum Cap
MAF Block-Off Plate, Gasket, and Hardware.
Note:
This kit is designed to provide proper frequency and location of the mass airflow sensor used with GM Controllers.
May require modifications based on the wide applications our engines are installed into. Custom installation and modification may be required.
BluePrint Engines Dyno Calibration is tuned with this kit in place on our BPPLS530 controller packages.
may require modification such as drilling a hole for intake air temp on some models.



Yellow Exclamation Triangle
WARNING: Cancer and Reproductive Harm-
www.P65Warnings.ca.gov

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov