Water Temperature Sender Unit (66-69 Bronco)Find parts that fit my vehicle

1965-69 Ford, Mercury; Water Temperature Sender Unit; V8 Engine; for Vehicles with In Dash Gauge
Replacement water temperature sending unit with 3/8"- 18 NPT thread. This brass sensor screws into intake manifold to activate the temperature gauge in the dash. This is an accurate reproduction of the original part for various 1967-69 Ford and Mercury models with V8 engine and temperature gauge in the dash. However, you can use this temperature sending unit on a wide variety of 1965-69 Mustang models with gauges as a service part.

Note: Replaces Ford Part #: C6DZ-10884-B (SW-552) or C9WY-10884-A (SW-888). Designed for 1965 models that were built after Sept. 1st 1965. The 1969 351 Windsor temperature sending unit is obsolete. This temperature sending unit is recommended as the closest replacement.

Temperature Sending Unit Specifications:
Temp Sender Switch Temp Rating : 15.2-19 Ohms Resistance At 220 Deg F
Temperature Switch Thread Size : 3/8" x 18 NPT
Engine Applications:
6 cylinder
8 cylinder 289, 302, 351W, 390, 427, 428

Fitment:

• 1966 Ford Bronco
• 1967 Ford Bronco
• 1968 Ford Bronco
• 1969 Ford Bronco

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov