Chevy Truck Bed End Hole Cap, Stepside, With Red LEDs, 1967-1987
Item EK-61-255173-1
Product Information
Features, Description, Q&A
Features
- Improves Safety By Adding Stylish Additional Turnsignals & Taillights Into The Bed Curls
- Modern LED's Will Burn For Thousands Of Hours
- Made In USA
- Ecklers Legacy Number: 131358
Description
Includes 12 volt dual intensity 19 LED bulb, and 3 pigtail wires. Can be used for turn signals and taillights. These aluminum caps are made to fit in the ends of the bed sides. A rubber o-ring aids in installation and helps the caps stay in place. There are variations in the bed side curls, so we suggest you check the inside diameter of your curl before ordering. The size we make for this hole cap is 1-11/16 inches. The lighted hole cap will provide additional lighting at the rear of your truck, but is not intended to replace your DOT legal turn signal light system. LED's pull less power than original turn signal bulbs, so an electronic flasher must be used if you plan on using these as your only turn signals. The lenses are clear, but the LED's glow bright amber when powered. Made in
CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Questions & Answers