Performance Systems Integration Engine Controller Kit for LSA Supercharged Engine and Manual Transmission Swap

APPLICATION: 2009-15 CTS-V, CAMARO ZL1, GM CRATE ENGINES 6.2L Factory Supercharged LSA enginesCLICK FOR COMPONENT ID GUIDESEE DESCRIPTION BELOW FOR INCLUDED PARTS PARTS INCLUDED: Complete Engine Wiring Harness (4 Wire Hookup), Programmed Engine Controller (ECM), TCM Programming (Customer Supplied T43 TCM), Accelerator Pedal, LS3 Cartridge Mass Air Flow Sensor, Intake Tube W/ Mass Air Flow Sensor Bung, Oxygen Sensors (Qty. 2)NOTES: This COMPLETE controller kit from PSI includes everything you need to get that LSA engine running in your project vehicle. The kit also includes hardware and components that don't typically come with used engines, such as the wiring harness, mass airflow meter, pedal, oxygen sensors, oxygen sensor bungs, and programmed ECM - eliminating the need to source them separately. This controller system is a true stand-alone system for use in older vehicles, as all that's needed to get a vehicle running with it are power and ground sources, a 58-psi (400 kPa) fuel pump and an electric cooling fan.CONNECTIONS FOR:Fuse/Relay BoxFuel Pump Control (Relay included)Fan controls (Relays and fuse available separately KIT-1010)Check Engine Light, Speedo output, Tachometer, OBD2 PortIAC and TPS on DBC setupsMAF SensorMAP SensorEngine Coolant Temp SensorAlternator Control(2) Upstream Oxygen SensorsCrankshaft PositionCamshaft PositionFuel InjectorsCoil Pack Sub-HarnessAutomatic or Manual Transmission controlKnock SensorsConnections from the Harness You Will Need to Hookup:Fuel Pump (Required)Switched Ignition Power (Required)Malfunction Indicator (Check Engine, MIL, CEL, ETC.)SpeedometerTachometerFan 1 Relay Control (Low Speed or Single Control)Fan 2 Relay Control (High Speed or Second Fan Control)Fan Relays available separately KIT-1010These harnesses are designed for retrofitting '09-15’ LSA Supercharged engines (CTS-V, Camaro ZL1, & GM Crate Engines) and 6L80E/6L90E or T56/TR6060 Manual transmissions into older muscle cars and street rods or newer non-emissions controlled vehicles. They are completely plug and play with four wire hookup (switched power, constant power and ground connections required). Harnesses are designed with a sliding grommet seal and 4 - 5 feet of length from the rear of the cylinder head to the PCM mounting position under the vehicle dashboard. A sliding grommet seal allows for professional, leak proof installation.Harnesses are professionally constructed from Brand New GM Delphi Connectors and TXL (Polyethylene Cross Linked) High Temperature Wire to GM Specifications. All harnesses are 100% Quality Inspected prior to shipping. Note that harnesses are for non-emissions equipped vehicles and do not include air pump or EGR provisions. Please contact PSI for more information.*Don't forget to Mail In your Customer Supplied T43 TCM (located inside your 6L80e transmission). Here is a VIDEO to help with the removal and installation of the TCM.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov